Most painters have no problem painting doors in place, but they recommend you lay the door on sawhorses and work horizontally. If you have a paneled door, start with the panels and work from the outside edges in toward the center. "Watch the corners — paint loves to puddle," warns Dixon. While the paint is still wet, lightly "tip off" the panel with an almost dry brush. (Tipping off is pulling the brush over the surface to level out the finish.) When painting the stiles (vertical) and rails (horizontal) just follow the grain of the wood. When the grain changes abruptly, for instance, where the rail meets the stile, don't stop your brush stroke — you'll only leave a lump of paint. Apply paint across the joint with a full stroke, and then tip off the overlapping section by pulling the brush in the direction of the grain. "Make sure the door is dry before painting the opposite side or rehanging it," says Maceyunas.
Homer found inspiration in summer trips to the North Woods Club, near the hamlet of Minerva, New York, in the Adirondack Mountains. It was on these fishing vacations that he experimented with the watercolor medium, producing works of the utmost vigor and subtlety, hymns to solitude, nature, and to outdoor life. Homer doesn't shrink from the savagery of blood sports nor the struggle for survival. The color effects are boldly and facilely applied. In terms of quality and invention, Homer's achievements as a watercolorist are unparalleled: "Homer had used his singular vision and manner of painting to create a body of work that has not been matched."
The walls must be properly cleaned prior to applying primer or paint. This involves using a mixture of soap and water. Nail holes, chips, cracks or other small imperfections should be filled in and evened with plaster and allowed to dry before the entire surface is lightly sanded down and wiped again. Once the wall is clean and dry, you should apply painter’s tape over surfaces you do not want painted. Be sure not to overlook ceiling corners and edges, baseboards and trims and moldings.
Most interior painting projects will present corners and edges. Corners, trims, splashes and accents will require cutting in — which generally requires the most patience, preparation and skill. There is a lot of debate among painters whether it is better to cut in before or after applying the roller. Solo painters may want to prepare the surfaces first, apply painter’s tape where required and cut in before applying paint to the rollers. Painters working in teams can split cutting in duties in sections while other team members are applying paint with rollers.
The right paint stroke to use in interior painting is highly debatable. It's not a talent as much as a skill that is learned through practice. Many experts paint in a “W” pattern when using foam rollers, but others simply roll up and down then sideways with either brushes or rollers. The motion isn’t as important as making sure that the application is even and drip-free across the entire area. However, technique is important when you're covering over wall repairs.