Repaint — exteriors especially — before visible signs of wear appear, Bancroft says. Don’t wait until you see peeling or flaking paint. “If I have to spend 40 hours preparing the surface before we can paint, that time is going to result in a lot of extra costs. But if I can spend 10 hours preparing the surfaces to be painted, you’re going to save money,” Freeman says.
If your home was built before 1979, the paint might contain lead, which is extremely hazardous to children age 6 and younger. Call your local public health department for information on how to check for lead and handle lead paint safely. For a free booklet on dealing with lead paint, contact the U.S. Environmental Protection Agency at www.epa.gov/lead.
Throughout the 1870s, Homer continued painting mostly rural or idyllic scenes of farm life, children playing, and young adults courting, including Country School (1871) and The Morning Bell (1872). In 1875, Homer quit working as a commercial illustrator and vowed to survive on his paintings and watercolors alone. Despite his excellent critical reputation, his finances continued to remain precarious.[18] His popular 1872 painting Snap-the-Whip was exhibited at the 1876 Centennial Exposition in Philadelphia, Pennsylvania, as was one of his finest and most famous paintings Breezing Up (1876). Of his work at this time, Henry James wrote:
Most painters have no problem painting doors in place, but they recommend you lay the door on sawhorses and work horizontally. If you have a paneled door, start with the panels and work from the outside edges in toward the center. "Watch the corners — paint loves to puddle," warns Dixon. While the paint is still wet, lightly "tip off" the panel with an almost dry brush. (Tipping off is pulling the brush over the surface to level out the finish.) When painting the stiles (vertical) and rails (horizontal) just follow the grain of the wood. When the grain changes abruptly, for instance, where the rail meets the stile, don't stop your brush stroke — you'll only leave a lump of paint. Apply paint across the joint with a full stroke, and then tip off the overlapping section by pulling the brush in the direction of the grain. "Make sure the door is dry before painting the opposite side or rehanging it," says Maceyunas.
Every painting job develops a unique choreography as ladders go up and come down and tarps are unrolled and folded up. But two basic principles remain: 1) Start at the top and work down. 2) Work in the shade, out of the sun's glare. As the dance proceeds, keep an eye on the weather. Rain can wash freshly applied latex right off the wall, and a temperature dip below 50 degrees F two days after application can interfere with adhesion and curing and dull the sheen of glossy paints. (Latexes like Sherwin-Williams's Duration and Benjamin Moore's MoorGard Low Lustre are formulated to tolerate temps as low as 35 and 40 degrees, respectively.)

Disclaimer: NerdWallet strives to keep its information accurate and up to date. This information may be different than what you see when you visit a financial institution, service provider or specific product’s site. All financial products, shopping products and services are presented without warranty. When evaluating offers, please review the financial institution’s Terms and Conditions. Pre-qualified offers are not binding. If you find discrepancies with your credit score or information from your credit report, please contact TransUnion® directly.

The materials of the home’s facade should be considered before painting your home. When painting flat surfaces like siding or wood, you can opt for standard outdoor paint. When painting a textured surface like stucco or brick, “elastomeric” paint is a much better choice. This type of paint can stretch more than normal paint, which allows it to bridge over small gaps and crevices, painting smoothly over texture.
Hi Donnie, Thanks for your comment! We would be happy to help you connect with a fencing pro to give you an estimate on your project. You can submit a request to our pros here: www.homeadvisor.com, browse a list of local pros here: http://www.homeadvisor.com/c.html, or send your info to [email protected] and a project advisor will reach out to assist you. –HASupport
Concrete walls must always be prepared before painting, but in some cases previous finishes will also have to be removed so that paint doesn't peel or chip off. Additionally, special sealants, primers and paints may be applied to ensure concrete's endurance in face of the specific elements. Depending on the wall's condition and exposure to the sun, painting professionals will usually estimate between $500 (~250 sq. ft.) and $2,000 (~1,000 sq. ft.), depending on wall area to cover.
In some cases, professional painters may include additional charges for specialized equipment that homeowners can't purchase on their own. Because professionals have licenses and access to such equipment, it's simpler to let them get those themselves. But providing some of the smaller equipment and extras directly really can help to cut down on the total cost of your project.

Most interior painting projects will present corners and edges. Corners, trims, splashes and accents will require cutting in — which generally requires the most patience, preparation and skill. There is a lot of debate among painters whether it is better to cut in before or after applying the roller. Solo painters may want to prepare the surfaces first, apply painter’s tape where required and cut in before applying paint to the rollers. Painters working in teams can split cutting in duties in sections while other team members are applying paint with rollers.
The right paint stroke to use in interior painting is highly debatable. It's not a talent as much as a skill that is learned through practice. Many experts paint in a “W” pattern when using foam rollers, but others simply roll up and down then sideways with either brushes or rollers. The motion isn’t as important as making sure that the application is even and drip-free across the entire area. However, technique is important when you're covering over wall repairs.
To remove a bad piece of siding, you have to pull out two rows of nails: the ones in the bad board itself, and those in the board directly above. Siding is thin and splits easily, so the tricky part of this job is pulling nails without damaging surrounding boards. A cat’s paw is the best tool for digging out nails if damage to the surrounding wood doesn’t matter (Photo 1).

I am in northern Nevada and you have not yet gotten sufficient responses to provide a painting cost chart showing the averages.  I do have a quote from an outside (Not Homeadvisor referral) painter who is local for $2,750 for soffits, patio cover and posts, Garage facia (redwood clapboard above (~300 ? Sq. Ft.) on a 2046 Sq. Ft. home where the walls are 9 ft tall and it is fully stuccoed with plastic stucco surfaces, so not being painted.  

It's okay to receive ballpark figures over the phone however, insist upon an in-home estimate. A quality painter will help point out why certain parts of the project might be more expensive and can even talk through the repair process if it's necessary. A painter should also ask questions regarding access to the painting site, where they should park and if any HOA rules prohibit hours of work.


A painter's rod, or pole, can help you paint ceilings more quickly — no climbing up and down ladders required. And there's no need to stand directly underneath the area you are painting, so you won't catch every wayward splatter. A pole is also great for walls and floors. The pros were split over whether the 4- or 8-foot pole is best for everyday use, but they all agreed that a telescoping rod is the best bet.
Most painters have no problem painting doors in place, but they recommend you lay the door on sawhorses and work horizontally. If you have a paneled door, start with the panels and work from the outside edges in toward the center. "Watch the corners — paint loves to puddle," warns Dixon. While the paint is still wet, lightly "tip off" the panel with an almost dry brush. (Tipping off is pulling the brush over the surface to level out the finish.) When painting the stiles (vertical) and rails (horizontal) just follow the grain of the wood. When the grain changes abruptly, for instance, where the rail meets the stile, don't stop your brush stroke — you'll only leave a lump of paint. Apply paint across the joint with a full stroke, and then tip off the overlapping section by pulling the brush in the direction of the grain. "Make sure the door is dry before painting the opposite side or rehanging it," says Maceyunas.

After painting the ceiling, work from the top down: Start with the crown molding, then do the walls and then paint the casement molding around the windows and doors. Do baseboard molding last. "Painting the baseboards last keeps dust and grit from traveling off the floor, onto the brush and then up onto the freshly painted casements," explains Weeks.
I'm a 12 year Navy Veteran with a 1950's home and multiple late model vehicles that keep me busy and my skills sharp. Based in Norfolk I'm central to the 7 cities of Hampton Roads so no problem is too far. I do prefer more technical projects, home theater/computers/home network/Audio Visual/Electrical/Electronics/Etc, but will gladly knock out various other tasks. What can I help you with today?
we only use the best interior paint which goes further as far as pricing a repaint we charge 2.00 a square foot floor space for walls ceilings and trim .on new construction using the best paint 3.90 per foot floor space that is with 3 coats on all surfaces but as being a professional for 45 years i recommend use a professional so that your paint will last longer and you wont have to pay to have it done more often i do free consulting in these areas i am more than happy to assist you with your projects 864-506-6666 just always remember good paint last longer and use a washable paint your home is your most valueable investment take care of it
Stucco is a specialized material that requires extensive preparation work (cleaning, caulking, filling in cracks, etc.). Additionally, paint suitable for rolling or brushing over stucco varies greatly depending on location and climate conditions. Some stucco paint varieties will chip and peel away in certain climate conditions, so painting professionals won't recommend them. These factors make stucco one of the more expensive siding materials to cover. You can expect to pay anywhere from $900 (~500 sq. ft.) to $3,000 (~1,500 sq. ft.) to have stucco revitalized with paint, depending on how much is needed to cover the home exterior.
Grand Prairie, TX ServicesGRAND PRAIRIE, TXBrick and Stone Driveway Installation GRAND PRAIRIE, TXLawn & Garden Services GRAND PRAIRIE, TXStructural Engineers GRAND PRAIRIE, TX Carpet InstallerGRAND PRAIRIE, TXTree Services GRAND PRAIRIE, TXFaux Painting GRAND PRAIRIE, TXDesignBuild GRAND PRAIRIE, TXCable Wiring GRAND PRAIRIE, TXMold Removal GRAND PRAIRIE, TXRoofing
To remove a bad piece of siding, you have to pull out two rows of nails: the ones in the bad board itself, and those in the board directly above. Siding is thin and splits easily, so the tricky part of this job is pulling nails without damaging surrounding boards. A cat’s paw is the best tool for digging out nails if damage to the surrounding wood doesn’t matter (Photo 1).
This job is usually done by a professional house painter. The painter will assess the walls, clean, and make any necessary repairs or removal of old wall coverings. They will also tape off any adjacent surfaces and cover nearby furniture and floors with drop cloths. Typically, they will apply a layer of primer, then one to three coats of paint, depending on the color and coverage. Once the paint is dry, they take a final walkthrough to inspect and make any necessary touch ups.
×