Before exhibiting at the National Academy of Design, Homer finally traveled to Paris, France in 1867 where he remained for a year. His most praised early painting, Prisoners from the Front, was on exhibit at the Exposition Universelle in Paris at the same time. He did not study formally but he practiced landscape painting while continuing to work for Harper's, depicting scenes of Parisian life.
To get at the nails in the board above, shove a flat pry bar up under it and gently pry the board outward. In most cases, this will pop up the nailhead, so you can pull it with your hammer claw. If you run into a stubborn nail that won’t move easily, don’t use brute force and risk splitting the good board. Instead, slip a hacksaw blade behind the siding and cut the nail (Photo 2).You can’t get the new board in unless you pull the remaining shank of the cut nail (Photo 3).
Also prime the ends of adjoining boards. This step pays off by slowing the moisture penetration that can lead to peeling at the joints. If the new siding is redwood or cedar, buy a special “stainblocking” primer. Both of these woods contain natural chemicals (tannins) that can bleed through paint, causing brownish stains. A stain-blocking primer will seal in the tannins.
The cost to paint metal siding -- most commonly aluminum and galvanized steel -- will depend on a variety of factors. In some instances, a simple cleaning will suffice to prepare metal siding for painting. In worst cases, painting professionals will need to repair metal that is rusted, damaged or missing pieces due to climate conditions. In the case of severe damage, a professional will have to remove the old finish and paint to get to the original layer, which will add on to the final price. When you add the actual painting of the metal siding, you might be looking at a final bill between $400 (~250 sq. ft.) and $1,500 (~1,000 sq. ft.).
The right paint stroke to use in interior painting is highly debatable. It's not a talent as much as a skill that is learned through practice. Many experts paint in a “W” pattern when using foam rollers, but others simply roll up and down then sideways with either brushes or rollers. The motion isn’t as important as making sure that the application is even and drip-free across the entire area. However, technique is important when you're covering over wall repairs.