It's okay to receive ballpark figures over the phone however, insist upon an in-home estimate. A quality painter will help point out why certain parts of the project might be more expensive and can even talk through the repair process if it's necessary. A painter should also ask questions regarding access to the painting site, where they should park and if any HOA rules prohibit hours of work.
Since 1980, House Painting Inc. has aimed for excellence in painting contractor services. Our painters specialize in extensive prep work for the best finished painting results. We respond quickly to customer requests for estimates and job starts. We have earned our reputation as the best painting company in Los Angeles, Pasadena, Santa Monica and the surrounding area.
O'Neil patches shallow holes and divots with Ready Patch because it dries fast, sands smooth, and stays flexible. Deep cracks and rotten spots are best repaired with two-step epoxies, such as those made by Advanced Repair Technology. (For a step-by-step instructions, see Repairing Rot with Epoxy.) The days of using polyester auto-body fillers on wood are over. "They cure too hard," says Portland, Oregon–based painting contractor Kathleen George. "They look good at first, but then they peel away."
The pros were split on this tip. "Masking tape is problematic," says Mark Dixon, a painter in Missoula, Montana, and author of "House Painting Inside and Out" (Taunton Press, 1997). "Paint can bleed behind the tape, or remove the paint it's stuck to." Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) On the other hand, "If you can't cut in, you can't beat tape," says Span. The pros we spoke with all recommend painter's (blue) tape because it's easier to remove than masking tape. To prevent bleeding, Span uses a putty knife to bed the tape. After letting the paint dry, he scores the edge of the tape line with a utility knife to avoid tearing the paint.
To get basic measurements, measure the length and width of each wall you want to paint in inches. Multiply the length and height together, and divide by 144. This will give you the square footage for each wall. A gallon of paint typically covers around 400 square feet. In some cases, you may need a primer 2 first, then a single coat of paint, meaning that you may need one gallon of primer and one gallon of paint to cover 400 square feet. However, if the wall requires multiple coats, this will increase the total amount of square footage required, and therefore the amount of paint.
The right paint stroke to use in interior painting is highly debatable. It's not a talent as much as a skill that is learned through practice. Many experts paint in a “W” pattern when using foam rollers, but others simply roll up and down then sideways with either brushes or rollers. The motion isn’t as important as making sure that the application is even and drip-free across the entire area. However, technique is important when you're covering over wall repairs.