Small random-orbit or pad sanders make this job go faster. (Wallis first covers these boundaries with Synkoloid patching compound so no edge is visible after sanding.) As shown, you want to make sure that there is a feathered, smooth transition from exposed wood to old paint. For areas that might get close scrutiny, you can follow up with a 100- or 120-grit rubdown to erase any scratches.

Specify whether the contractor or you will supply the paint. Check Consumer Reports' paint ratings: In its tests, some relatively inexpensive paints performed better than more expensive paints and cost $10 to $20 less per gallon. But keep in mind that most paints will resist cracking, peeling, mold and mildew. Who does the painting — and how well they do it — is more important than what's in the bucket.

Home Painters Company


"Modern paints dry too quickly, and are difficult to brush out," says Dixon, who uses paint additives, such as Floetrol for latex paints and Penetrol for alkyds. "Adding a few ounces per gallon slows drying time and makes the paint more workable," he says. Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) Although there are mildewcide additives, our pros prefer using bathroom and kitchen paints that have built-in mildew fighters. "These paints will prevent mildew from forming, but they won't kill mildew that's already there," Dixon points out. Because leftover mold spores can live beneath the paint and eventually work their way through to the surface, you should also prep bath and kitchen surfaces. First, wash down the walls with a bleach solution (3/4 cup of bleach per gallon of water) then seal with a stain-blocking primer, such as Zinsser's Bulls Eye 1-2-3 or Kilz's Total One.


To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges

You can save a bundle by doing the labor yourself. The biggest DIY expense is paint. Other expenses include buying or renting supplies and equipment, like caulk, primer, brushes, rollers, tarps and ladders or scaffolding. Freeman advises applying paint with brushes, not a sprayer. “If you overspray all the window frames and overspray your shingles and your sidewalks and the brick on the front of the house, you do damage that is not easily fixed,” he says.
I am getting quotes to paint the exterior of a 2,500 sq ft split levei home that just had all new windows and pre-primed Hardiplank installed 3 months ago. the quotes are up to $2,500 different ranging from power wash,prime again 3 coats of paint to no powerwash needed so soon and one coat of paint.. All quotes include trim. One includes complete replacement of 80 feet facia boards another just 40 feet.
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges
A thorough scrubbing is a must before painting any exterior surface. It removes the dirt and broken-down paint residues that keep fresh coats from adhering and gets rid of mildew that grows on paint in all but the most arid climates. Most contractors clean with pressure washers, but in the hands of someone unfamiliar with the equipment, these can gouge wood, shatter glass, and drive water behind siding and trim. Using a hose, a pump sprayer, and a scrub brush is slower but safer, and just as effective.
Gray is a timeless color, but it could also be considered drab if not accessorized with bold colors. Anyone who has grown tired of looking at white paint on walls for years should consider gray tones. Gray paint is cooler than its white counterpart and more versatile, as it manages to blend well with most decorations. It is an ideal color for all interior spaces and provides the perfect backdrop for color bursts.
Disclaimer: NerdWallet strives to keep its information accurate and up to date. This information may be different than what you see when you visit a financial institution, service provider or specific product’s site. All financial products, shopping products and services are presented without warranty. When evaluating offers, please review the financial institution’s Terms and Conditions. Pre-qualified offers are not binding. If you find discrepancies with your credit score or information from your credit report, please contact TransUnion® directly.
Being in the business for 25+ years I have had the privilege of working with thousands of clients. Although they all came from different circumstances and backgrounds they all had one common goal in mind. Every one of them wanted to be respected, receive top value for their money, and get the best possible paint job for their most prized possession, their house!
When you go to the home improvement store, find out how much 12 gallons of the paint you want would cost, and that will help you determine your cost. Maybe it's a low-quality paint that costs $30, in which case you're looking at about $360 for paint. If you choose high-quality paint that costs around $70, your total paint cost could be closer to $840. Professionals also recommend that you add an extra 10 or 20 percent to your total square footage, depending on the type of siding you have. Some textures require extra paint because they're rough. This is especially true with wood and stucco siding.
Pros prefer 5-gallon buckets with a roller grid to roller pans. They hold more paint than pans and, says Doherty, "It's tougher to tip over a bucket." A bucket also lets you box, or mix, two or three cans of paint to avoid color discrepancies. To use a bucket and grid, dip the roller a quarter of the way into the paint and run it over the ramp to work the paint into the nap.
Most interior painting projects will present corners and edges. Corners, trims, splashes and accents will require cutting in — which generally requires the most patience, preparation and skill. There is a lot of debate among painters whether it is better to cut in before or after applying the roller. Solo painters may want to prepare the surfaces first, apply painter’s tape where required and cut in before applying paint to the rollers. Painters working in teams can split cutting in duties in sections while other team members are applying paint with rollers.

The last big decision is how to apply the paint. Most pros use paint sprayers because they're fast, but in inexperienced hands a high-powered sprayer can leave drips, thin coats, and a mist that may land on many things other than your siding. If you do hire a painter who uses a sprayer, make sure he is meticulous about removing, covering, or masking off everything in the area that might get hit with overspray: gutters, roofs, windows, shrubbery, walkways, cars—you name it.

House Painter Company

×