Filling gaps with a paintable acrylic-latex caulk cuts down on drafts and makes your trim look better than new. The secret to using caulk is to cut the tip smaller than you think it should be; too much caulk makes a mess. Also, instead of using a nail to break the inner seal, use a small wire so you don't stretch out the nozzle. Also consider buying a dripless caulk gun, which will automatically back off the pressure after each pull on the trigger to prevent unwanted oozing.
Professional painters provide estimates primarily based on the square footage of your home. Painting an average home between 500 and 1,500 square feet can cost between $1,000 and $3,000. However, factors such as number of stories and ease of access can also affect the overall price. Homeowners report that the average cost to paint a house nationally is $2,581 and most pay between $1,714 and $3,682.
Over time, even the best paint job needs a new coat. Old paint peels and fades and those colors that were all the rage ten years ago can start to look a bit dated. With your busy schedule, you've got no time to pick up a paintbrush, and you've just remembered that your in-laws are in town for dinner next week! We hear stories like this all the time, and our reply is always the same: don't panic! Book a painting professional through the Handy platform. Wall painting shouldn’t be stressful and when you use the Handy platform, it won’t be.
Lap marks are those ugly stripes caused by uneven layers of paint buildup. They occur when you roll over paint that’s already partly dry. (In warm, dry conditions, latex paint can begin to stiffen in less than a minute!) The key to avoiding lap marks is to maintain a “wet edge,” so each stroke of your roller overlaps the previous stroke before the paint can begin to dry.
To begin, move everything out of the room. Every painter we spoke with had a horror story about the time he didn't follow Rule No. 1. Bigger pieces of furniture can sometimes be left covered in the center of larger rooms, but if you are repairing drywall, says Chris Span, of Span's Quality Painting in Mobile, Alabama, "Take everything out. Drywall dust goes everywhere." Remove doors, light fixtures and hardware, and label everything with masking tape. Also, invest in drop cloths. "It's surprising how well a few drops of paint can cover a floor," says Rich Maceyunas, of Maceyunas Painting and Wallpaper in Waterbury, Connecticut. Buy high-quality drop cloths, such as canvas or paper-backed plastic. (Paint soaks right through lightweight fabrics and bedsheets.) Plastic sheeting works, but it's very slippery and doesn't absorb drips.

Attic Fan Installation Bathroom Fan Repair Ceiling Fan Installation Ceiling Fan Repair Electric Wall Heater Installation Electrical Panel Installation Electrical Panel Repair Electrical Panel Upgrade Electrical Wiring Installation Electrical Wiring Upgrade Exhaust Fan Installation Holiday Lighting Installation LED Interior Light Conversion Light Fixture Installation Light Fixture Repair Light Fixture Replacement Light Switch Installation Outlet Installation Outlet Repair Spa Wiring Installation
Homer's career as an illustrator lasted nearly twenty years. He contributed illustrations of Boston life and rural New England life to magazines such as Ballou's Pictorial and Harper's Weekly[8] at a time when the market for illustrations was growing rapidly and fads and fashions were changing quickly. His early works, mostly commercial engravings of urban and country social scenes, are characterized by clean outlines, simplified forms, dramatic contrast of light and dark, and lively figure groupings—qualities that remained important throughout his career.[9] His quick success was mostly due to this strong understanding of graphic design and also to the adaptability of his designs to wood engraving.

Professional painters provide estimates primarily based on the square footage of your home. Painting an average home between 500 and 1,500 square feet can cost between $1,000 and $3,000. However, factors such as number of stories and ease of access can also affect the overall price. Homeowners report that the average cost to paint a house nationally is $2,581 and most pay between $1,714 and $3,682.


If less than half the old paint is left, however, it may be worth stripping it all off. Guertin gets rid of stubborn remnants using shrouded grinders (like the PaintShaver), infrared paint strippers (such as the Speedheater), or chemical strippers (like Multi-Strip), then smooths the wood with a course or two of sanding. When siding (or bank accounts) can't take the shock of a total strip job, Rich O'Neil, of Masterwork Painting in Bedford, Massachusetts, has successfully hidden rough, well-adhered paint under Peel Bond, a thick primer.


Concrete walls must always be prepared before painting, but in some cases previous finishes will also have to be removed so that paint doesn't peel or chip off. Additionally, special sealants, primers and paints may be applied to ensure concrete's endurance in face of the specific elements. Depending on the wall's condition and exposure to the sun, painting professionals will usually estimate between $500 (~250 sq. ft.) and $2,000 (~1,000 sq. ft.), depending on wall area to cover.


"Modern paints dry too quickly, and are difficult to brush out," says Dixon, who uses paint additives, such as Floetrol for latex paints and Penetrol for alkyds. "Adding a few ounces per gallon slows drying time and makes the paint more workable," he says. Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) Although there are mildewcide additives, our pros prefer using bathroom and kitchen paints that have built-in mildew fighters. "These paints will prevent mildew from forming, but they won't kill mildew that's already there," Dixon points out. Because leftover mold spores can live beneath the paint and eventually work their way through to the surface, you should also prep bath and kitchen surfaces. First, wash down the walls with a bleach solution (3/4 cup of bleach per gallon of water) then seal with a stain-blocking primer, such as Zinsser's Bulls Eye 1-2-3 or Kilz's Total One.

I'm a 12 year Navy Veteran with a 1950's home and multiple late model vehicles that keep me busy and my skills sharp. Based in Norfolk I'm central to the 7 cities of Hampton Roads so no problem is too far. I do prefer more technical projects, home theater/computers/home network/Audio Visual/Electrical/Electronics/Etc, but will gladly knock out various other tasks. What can I help you with today?


Homer found inspiration in summer trips to the North Woods Club, near the hamlet of Minerva, New York, in the Adirondack Mountains. It was on these fishing vacations that he experimented with the watercolor medium, producing works of the utmost vigor and subtlety, hymns to solitude, nature, and to outdoor life. Homer doesn't shrink from the savagery of blood sports nor the struggle for survival. The color effects are boldly and facilely applied. In terms of quality and invention, Homer's achievements as a watercolorist are unparalleled: "Homer had used his singular vision and manner of painting to create a body of work that has not been matched."[41]
If you're going to do any part of the painting or prep work on your own, you must know that the first step in preparing a surface is washing it. Since dirt can affect the smoothness of a surface area -- and therefore paint's adhesion to it -- use soap to remove any dirt or stains. Make sure there's no soap left on the walls when you're finished; also make sure to remove any gloss with sandpaper and vacuum up the leftover dust.
For interior jobs, make sure you've cleaned all of the awkward spots, including behind the toilet, and picked up any knickknacks that might get in the way (e.g., soap containers, loofahs, and kitchen organizers). Removing the switch plates and outlet covers from the walls also goes a long way toward speeding up painting time—and painters' time is (your) money.

As you scrape, you may find that the wood has turned gray or black in some areas. Check for rot by probing these areas with a nail. Spots that are discolored but firm are simply weathered. Weathered wood doesn’t hold paint very well, so sand away the gray surface. If you find soft areas, you’ve got rot. Small, shallow soft spots can be dug out and repaired with a two-part filler such as Minwax High Performance Wood Filler. But when rot is deep and widespread, it’s best to replace the entire piece of wood.
Your home is your most important asset and maintaining it is vital in upholding and increasing its value. As a full-service painting company, Home Works Painting will provide you with a superior professional painting experience. Our services include interior/exterior painting, drywall repair/installation, wood replacement, pressure washing, and color consulting. We stand behind our work by offering a six year warranty.
×